Online Shopping Now Available

Troubleshooting Your Spa

Water Gets Too Hot

Checking Thermostat and Heater Contactor:

Find the heater contactor in the control box (see picture below).

If it is not arced/welded shut and moves up and down freely, then the thermostat needs to be replaced. Thermostats are located in one of two places on a spa, either on the top of the spa (spa sides), or in a control box where the equipment is. See "thermostats" in Parts section. Replace the contactor if it was arced/welded shut. See "contactors" in Parts section. In some cases both of these will need to be replaced.

NOTE: Contactors arc or weld themselves shut due to "chattering" caused by:

	Low water level in spa
	Pressure switch out of adjustment
	Clogged or old filter
	Solid state thermostats

ONE MORE NOTE: Leaving your jets (jet pump) on for a long period of time may also cause the water to over heat.